All products of MONACOR INTERNATIONAL are tested continuously to ensure a constant quality level and to maintain the high quality standards. All products which
are subject to the CE guidelines as well as the electric
and electronic subassemblies which are subject to the
directive for motor vehicles, are tested to the respec-
tive standards and carry the CE mark. In consequence,
these products can be sold in all EC countries without
further tests or approvals.

General Information

• All rights reserved by MONACOR INTERNATIONAL GmbH & Co. KG. All contents of the catalogue ser-
  ve as information as to the products by MONACOR INTERNATIONAL only. No part of this catalogue in-
  cluding text, photos of products, graphics, or any parts thereof may be reproduced in any form or
  by any means for any commercial use without our express prior written consent.
• * Windows is a registered trademark of Microsoft Corporation in the United States and other coun-
  tries.
• We cannot be held responsible for printing error, should they occur.
• We reserve the right to make technical changes without prior notice.
• The technical specifications stated are according
  to the information of the manufacturer.
• Due to production tolerances technical data may vary slightly.
• Damage resulting from unauthorized servicing
  of the products thus causing changes, as well
  as improper handling resulting in consequential
  damage are excluded from the warranty. We will
  not be liable for changes of the state of the pro-
  ducts resulting from improper storage, other in-
  terventions or improper use.
• If the units are interfered with, the CE approval
  will no longer apply.
• All products are always suitable for indoor use
  only unless otherwise stated.
• The products do not correspond to the medical
  products directive 2007/47/EG.
• If the products are to be put out of operation
  definitively, they must be taken to a local re-
  cycling plant for disposal which is not harmful
  to the environment.

Technical Information

• Before first use of the products please read the
  instruction manual carefully!
• The products correspond to the directive for elec-
  tromagnetic compatibility 2004/108/EG and partly
  to the low voltage directive 2006/95/EG and their
  amendments.
• When operating with voltages of over 42 V, please
  always observe the respective safety measures.
• Before opening any products operated with 230 V
  mains voltage, disconnect the products from the
  supply voltage!
• Make sure that the supply voltage is disconnected
  before working on components and modules. Exis-
  ting capacitors must be discharged.
• Mains connecting cables  and test cables have to
  be examined for damage regularly. Never pull on
  the cable to disconnect the plug from the socket.
• Mains connecting cables and mains fuses must only be replaced by skilled personnel.
• Unless otherwise stated:
  – protect the products from humidity and heat,
  – always observe the admissible ambient temperature of 0–40 °C.
• Do not use a very high volume level when using headphones. Permanent high volume may damage your hearing!
• A soldering process which is too long and too hot may cause damage to the corresponding products. Choose a soldering temperature that is suitable for the material used. No liability can be assumed for damage to the product or consequential damage caused by improper handling.
• The plugs, jacks, switches, rotary switches, and potentiometers shown in this catalogue are only suitable for connection to safety extra low voltage (SELV) or signal voltage unless the item is desig-
  ned for a higher voltage (see text or table).
• If the fixing nuts of chassis mount jacks or chas-
  sis plugs are tightened too much, this may cause
  damage to the whole component. In case of im-
  proper handling no liability can be assumed for
  this or consequential damage.
• The heat must be eliminated by air circulation. Therefore do not cover ventilation slots with any­thing. Do not put or drop anything through the ventilation slots. Otherwise there will be danger
  of an electric shock.
• Only use a dry, soft cloth for cleaning the products. Chemicals must not be used in any case.